Earth/Ground Instructions; Check Installation - JLA 98 Installation & Operation Manual

Installation
To reduce the risk of an electric shock or fire, DO
NOT use an extension cord or an adapter to connect
the washer to the electric power source.
Machine Must Be Hard Wired
NOTE: Electrical disconnect must be located so that
it is easily accessible with machine in place. Ma-
chine must be hard wired. An intermediate shut-off
box that provides all pole disconnection from the
supply mains must be used in compliance with all
local electrical codes.
Figure 21

Earth/Ground Instructions

This appliance must be properly connected to protective earth/
ground. In the event of malfunction or breakdown, the earth/
ground will reduce the risk of electric shock by providing a path
of least resistance for electric current.
The washer must be hard wired into an appropriate power source
that is properly installed and connected to a protective earth/
ground in accordance with all local codes and ordinances.
Improper connection of the equipment earth/ground
conductor can result in a risk of electric shock.
Check with a qualified electrician or service person if
you are in doubt as to whether the washer is proper-
ly connected to a protective earth/ground.
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
WARNING
FLW2327N_SVG
WARNING
If the laundry room's electrical supply does not meet the above
specifications and/or if you are not sure the laundry room has an
effective earth/ground, have a qualified electrician or your local
electrical utility company check it and correct any problems.
W082
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.

Check Installation

1. Refer to Installer Checklist on the back cover of this manual
and make sure that unit is installed correctly.
2. Run washer with a test load to make sure it is operating prop-
erly and properly leveled.
a. Put about six pounds of laundry (four bath towels and
three jeans) into washer.
b. Close door.
c. Rapid advance to the final spin part of the cycle.
d. When washer spins at high speed, verify that it is stable.
e. If it is not, after cycle is complete, refer to Position and
Level the Washer to readjust leveling legs.
W822
20
WARNING
Part No. 805412R7
W299