Installation; Before You Start; Tools; Opl Models - JLA 98 Installation & Operation Manual

Before You Start

Tools

For most installations, the basic tools you will need are:
3
7
1. Safety Glasses
2. Wood Block
3. Wrench
4. Screwdriver
5. Pliers
6. Socket Wrench
7. Gloves
8. Level
NOTE: An 8 in. [20.32 cm] coin drawer is required for
coin operated models.
NOTE: If the washer is delivered on a cold day (below
freezing), or is stored in an unheated room or area dur-
ing the cold months, do not attempt to operate it until
the washer has had a chance to warm up.
NOTE: Install dryer before washer. This allows room for
attaching exhaust duct.
NOTE: Some moisture in the wash drum is normal. Wa-
ter is used during testing at the manufacturer.
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT

Installation

1
2
4
5
8
FLW2376N_SVG
Figure 1
NOTE: This appliance is suitable for use in countries
having a warm, damp climate.

OPL Models

The machine is shipped from the factory with the Electronic Con-
trol Diagnostic Harness Assembly unplugged. To avoid unauthor-
ized manual programming perform the following steps.
1. Open control panel.
2. Locate diagnostic harness on electronic control.
3. Plug connectors for "white/black" wire and "red/ blue" wire
together.
Control Panel
6

Order of Installation Steps

The proper order of steps must be followed to ensure correct in-
stallation. Refer to the list below when installing your unit.
1. Position washer near the installation area.
2. Remove the shipping materials.
3. Connect the fill hoses.
4. Install the washer's electrical cord.
5. For non-gravity drain models, connect the drain hose to the
drain receptacle.
6. For gravity drain models, connect the drain outlet to the drain
system.
7. Position and level the washer.
8. Wipe out inside of the washer.
9. Connect the washer to electrical power.
10. Check installation.

Position Unit Near Installation Area

Move unit so that it is within 4 feet [1.2 meters] of the desired
area of installation.
10
DRY2723N_SVG
Figure 2
Part No. 805412R7
Installation