General Control - Sharp CP-BH250 Operation Manual

General control

TIMER
REMOTE
SENSOR
RRMCGA409AWSA
■ To turn the power on
The first time the unit is plugged in, the unit will enter the
demonstration mode.
Function Main unit
Power on/
off
Demo /
Bluetooth ____
Standby
Eco mode
____
Note:
During demonstration or Bluetooth standby mode, NFC
function is activated once your device touches the NFC
detection area.
■ Display brightness control
To dim the display brightness, press the DIMMER button
on the remote control.
(Display is dim).
DIMMER 1
(Display gets dimmer).
DIMMER 2
(Display is bright).
DIMMER OFF
■ Volume auto fade-in
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 16 and fades in to the
last set level.
Remote
Operation
control
Press to turn the
power on or to
go to standby
mode.
Press to enter
demonstration
or Bluetooth
standby mode.
(During Power
off)
Press to enter
low power
consumption
mode. (During
Power off)
■ Volume control
Turn the volume knob toward VOLUME +/– (on main
unit) or press VOL +/– (on remote control) to increase or
decrease the volume.
■ Muting
To mute the volume, press the
Press again to restore the volume.
■ X-BASS control (remote control)
When the power is first turned on, the unit will enter the
extra bass mode which emphasizes the bass frequencies,
and "X-BASS" will appear. To cancel the extra bass mode,
press the X-BASS button.
■ Bass control (remote control)
Press the BASS button to select "BASS".
1
Within 3 seconds, press the VOL (+ or -) button to
2
adjust the bass.
■ Treble control (remote control)
Press the TREBLE button to select "TREBLE".
1
Within 3 seconds, press the VOL (+ or -) button to
2
adjust the treble.
■ Direct key power on function
When you press any of the following buttons, the unit turns
on.
● BLUETOOTH (PAIRING), CD, USB, AUDIO IN,
TUNER (BAND) button (remote control): Selected
function is activated.
button (main unit or remote control): The unit
●
turns on and playback of the last function will start
(Bluetooth, CD, USB, AUDIO IN, TUNER).
(on main unit/remote control): Disc tray opens and
●
the last selected function is activated.
■ Auto power off function
The main unit will enter the standby mode after 15 minutes
of inactivity during:
AUDIO IN: No detection of input signal or very low sound
audibility.
CD / USB: In the stop mode.
Bluetooth: In the pause or stop mode and no incoming
signal from a source device.
■ Function
Press the FUNCTION button on the main unit repeatedly
to select desired function.
CD FM STEREO
BLUETOOTH
Note:
The backup function will protect the memorized function
mode for a few hours should there be a power failure or
the AC power cord becomes disconnected.
E-8
button (remote control).
FM MONO AM
AUDIO IN USB