LG RN1870AH1 Owner's Manual page 24

24
PROGRAMMING MODE
3-4. Sensor dry apply or not setup (Use only for OPL type)
Entering set up
mode.
You will see LqC1
NOTE
• PrSH (Pre-wash apply or not) is not available in dryer.
Press the High Temp. button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Display .
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Press Med Temp. or Low Temp. button and then select
or .
Disable
Enable
Press the Start button.
The machine sets up the Vend type, then advances to the next
process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/off toggle switch
• Card type - Pull the service card
• OPL/Coin type – Press "High Temp. " twice
Button Display
One or the other will
display.