Table of Contents
Advertisement
ADDITIONAL INFORMATION
Warning indicators
When the warning indicators (see below) light up or flash, the projector will automatically shutdown:
‡
"Lamp" LED indicator is lit red and if "Power" indicator flashes red.
‡
"Temp" LED indicator is lit red and if "Power" indicator flashes red. This indicates the projector has
overheated. Under normal conditions, the project can be switched back on.
‡
"Temp" LED indicator flashes red and if "Power" indicator flashes red.
Unplug the power cord from the projector, wait for 30 seconds and try again. If the warning indicator lights up or
flashes, please contact your nearest service center for assistance.
LED lightning messages
Message
Standby state
(Input power cord)
Power on (Warming)
Power on and Lamp lighting
Power off (Cooling)
Error (Lamp failure)
Error (Fan failure)
Error (Over temp.)
‡
Power off:
‡
Temperature warning:
Please:
1. Make sure air in and outlets are not blocked.
2. Make sure the environment temperature is under 45 degree C.
If the problem persists in spite of the above.
Please contact a service center for repair.
Power LED
(Red)
Steady light
0.5 sec on). Back to
red steady light when
cooling fan turns off.
Flashing
Flashing
Flashing
Power Off
Press power key again.
Warning
TEMPERATURE TOO HIGH
Temp LED
(Green or Blue)
Flashing
(0.5 sec off /
0.5 sec on)
Steady light
Flashing
(0.5 sec off /
Steady light
Lamp LED
(Red)
(Red)
Steady light
Flashing
69
English
Advertisement
Table of Contents
