Table of Contents
Advertisement
USING THE PROJECTOR
Setup power settings menu
Direct Power On
Choose "On" to activate Direct Power mode. The projector will automatically power on when AC power is supplied,
without pressing the "Power" key on the projector keypad or on the remote control.
Signal Power On
Choose "On" to activate Signal Power mode. The projector will automatically power on when a signal is detected,
without pressing the "Power" key on the projector Keypad or on the remote control.
Note:
‡
If the "Signal Power On" option is turned "On", the power consumption of the projector in standby
mode will be over 3W.
‡
This function is applicable with HDMI source.
Auto Power Off (min.)
Sets the countdown timer interval. The countdown timer will start, when there is no signal being sent to the
projector. The projector will automatically power off when the countdown has finished (in minutes).
Sleep Timer (min.)
Sets the countdown timer interval. The countdown timer will start, with or without a signal being sent to the
projector. The projector will automatically power off when the countdown has finished (in minutes).
Note:
The Sleep Timer is reset every time when the projector is powered off.
Power Mode (Standby)
Set the power mode setting.
‡
Active: Choose "Active" to return to normal standby.
‡
Eco: Choose "Eco." to save power dissipation further < 0.5W.
Note:
Power Mode (Standby) is available only in models that support the network function, such as XGA, WXGA,
1080p 1.3x, 1080p Short Throw model, and 1080p 1.6x.
Setup security menu
Security
Enable this function to prompt for a password before using the projector.
‡
On: Choose "On" to use security verification when the turning on the projector.
‡
Off: Choose "Off" to be able to switch on the projector without password verification.
Note:
The default password is 1234.
Security Timer
Select the time (Month/Day/Hour) function to set the number of hours the projector can be used. Once this time has
elapsed you will be requested to enter your password again.
Change Password
Use to set or modify the password that is prompted when turning the projector on.
Setup keypad settings menu
Keypad Lock
When the keypad lock function is "On", the Keypad will be locked. However, the projector can be operated by the
remote control. By selecting "Off", you will be able to reuse the Keypad.
39
English
Advertisement
Table of Contents
