Maintenance - Genesis GLRT04V50 Operator's Manual

Aluminum Oxide Sand paper, Grinding
Stones, Wheels and Points (Red/Brown):
Aluminum oxide Bits are for grinding and shaping metals of all kinds. Sharpen
scissors, screwdriver tips, tools, blades, milled, uneven surfaces. De-burr metal pieces after cutting. Clean up
welds. Remove rust. Re-sharpen with provided dressing stone.
Silicon Carbide Grinding Stones, Wheels
& Points (Blue):
Silicon Carbide Bits are for grinding and shaping very hard materials, such as glass, ceramics, and stone. Re-
sharpen with provided dressing stone.
Diamond Grinding Points:
Diamond Grinding Points in many shapes and sizes can be used to shape, cut, carve, and engrave in very hard
materials such as brick, masonry, concrete, glass, ceramics, porcelain, and stone.
Engraving Cutters:
engraving Cutters of different shapes and sizes are used for intricate engraving, routing, and carving in wood,
plastic, and soft metals.
High Speed Drill Bits:
for fast drilling of holes in plastic, wood, and softer metals.
Fiberglass Cut-Off Wheels and Emery Cut-Off
Discs:
Cut-off Discs and Wheels of various thicknesses are used for cutting
and slotting all types of metals, plastics, and very thin wood pieces.
The cut-off wheels must be mounted on the provided mandrel to be used. Loosen and remove the screw in the
top of the mandrel. Position the wheel between the two pink grommets. Replace and tighten the screw to secure
the wheel.
Felt Polishing Wheels, Bonnets, and Points:
Use these (with polishing compound, if you like) to polish metals and plastics of various shapes
and sizes. Use with screw mandrel.
Flap Wheel Sander:
This long-lasting attachment can do light grinding of metals, and handle all shapes
and contours of woods and plastics for light to heavy sanding operations.

MAINTENANCE

CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. Consequently, we do not recommended using this tool for extended work on these
types of materials. However, if you do work with any of these materials, it is extremely important to clean the
tool using compressed air.
LUBRICATION
This tool is permanently lubricated at the factory and requires no additional lubrication.
10
Do not at any time let brake fluids, gasoline, petroleum-based
4V Cordless Rotary Tool
Operator's Manual GLRT04V50