Maintenance - Genesis GLVC08B Operator's Manual

CHARGING THE BATTERY (FIG 2)
NOTE:
Always Check that the power supply corresponds to the voltage on the ratings plate.
•
Insert the battery into the vacuum.
•
Connect the charging adaptor (6-fig 1) to the charging port (13).
•
Plug the adaptor into a 120 Volt AC power source. One of the GREEN indicator lights (5-fig 1) will flash
indicating the level of charge.
•
When all three indicator lights are solid, the battery has finished charging.
•
To remove the battery from the vacuum, slide the battery locking tab (11) to release the battery pack.
•
The battery may become warm while charging. This is normal.
•
If the battery is hot after continuous use in the tool, allow it to cool down to room temperature before
charging. This will extend the life of your batteries.
NOTE:
It takes approximately 3-5 hours to charge up a completely discharged battery.
USING THE VACUUM
•
Insert the battery pack. Turn on the vacuum by pressing the ON/Off switch (1-fig 1).
•
If more power is desired, press and hold the MAX/Turbo switch (2-fig 1).
•
The standard nozzle should be used for most vacuuming applications.
•
To get into tighter areas such as between car seats, insert the crevice tool with brush (8-fig 1) into the end
of the standard nozzle.
•
for smaller and more difficult to clean materials, use the dust brush to move the material as you clean.
NOTE
: To ensure proper suction and prevent overheating, empty collection cup frequently.
WArNING:
USING THE INFLATOR
•
Remove the vacuum cap and collection cup with filters.
•
Insert the inflator nozzle (9-fig 1) into the air outflow port (14-fig 2).
•
Make sure the object to be inflated has the proper size valve to fit the nozzle.
•
Insert the nozzle into the valve of the object to be inflated, make sure the valve seals to prevent air escaping.
•
Select Standard or Turbo mode, and inflate to desired pressure.
•
When finished inflating, remove the inflator nozzle from the object, and close the valve.
WArNING:
HOW TO DEFLATE
•
Keep the collection cup in place, attach the inflator nozzle to the collection cup.
•
Insert the inflator nozzle into the valve of the object to be deflated.
•
Turn on vaccum, air will slowly be removed from the object.

MAINTENANCE

CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their use. use clean cloths to remove dirt, dust, oil, grease, etc.
WArNING:
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. Consequently, we do not recommended using this tool for extended work on these
types of materials. However, if you do work with any of these materials, it is extremely important to clean the
tool using compressed air.
8
Dry material pick up only. DO NOT pick up wet material or liquids.
To prevent bursting, do not over-inflate objects.
Do not at any time let brake fluids, gasoline, petroleum-based
8V Compact Vacuum/Inflator
Operator's Manual GLVC08B