Rear - Watchguard Firebox T25 Hardware Manual

Firebox T25 Hardware Guide

Rear

Rear view of the Firebox:
Serial Port (Console)
The leftmost port is an RJ45 serial console port. An RJ45 serial cable is not included with the
device.
USB Interfaces
The device includes two USB 3.0 interfaces. Connect a USB storage device for USB backup and
restore, or to store a support snapshot. For more information, see
Network Interfaces
The Ethernet interfaces have standard RJ45 connectors and support link speeds of 10, 100, or
1000 Mbps.
The Firebox T25 has five network interfaces. These interfaces are labeled 0/WAN, 1/LAN, 2, 3, 4.
Interfaces 1 to 4 only support full duplex connections. Make sure the Firebox
interfaces and network devices you connect to these ports are set to auto-negotiation
or full duplex. Interface 0 supports both half and full duplex connections.
Reset Button
This resets the device. To restore the device to factory-default settings, see
Default Settings
Power Switch
Controls the power supplied to the device. Move the switch to position 1 to power on the device, or
position 0 to power it off.
Power Input
An AC power adapter is included with your device. Connect the AC adapter to the device and to a
power source. The power supply tip is plus (+) polarity. Use only the supplied AC power adapter.
11
.
Fireware Help.
Restore Factory-
WatchGuard Technologies, Inc.