Rear - Watchguard Firebox T20 Hardware Manual

Network Interface Status Indicators
The Firebox T20 has five network interfaces. There are two status indicators for each interface.
Indicator Indicator Color
On
1000
Blinks (speed of blink increases as the data flow
Yellow
increases)
On
10/100
Green
Blinks (speed of blink increases as the data flow
increases)
Status
The Status indicator is lit when there is a management connection to the device. The Status indicator
is lit for 30 seconds after you connect to the device with the Fireware Web UI or the command line
interface. It is also lit when the device is polled by WatchGuard System Manager.
Mode
The Mode indicator shows the status of the external network connection. If the device can connect
to the external network and send traffic, the indicator is green. The indicator flashes if the device
cannot send traffic to the external network.
Attn
The Attn indicator is yellow when you start the device with the Reset button pressed. For more
information, see
Power ( )
The Power indicator is lit to indicate power status. It is green when the Firebox is powered on.

Rear

Rear view of the Firebox:
Serial Port (Console)
The leftmost port is an RJ45 serial console port. An RJ45 serial cable is not included with the device.
WatchGuard Technologies, Inc.
Restore Factory-Default Settings
WatchGuard Firebox T20/T20-W Hardware Guide
Interface Status
Link speed: 1000 Mbps
Data sent and received
Link speed: 10 Mbps or 100
Mbps
Data sent and received
.
vii