ACIQ -24-AHB Quick Start Manual

ACIQ -24-AHB Quick Start Manual

Next gen ducted heat pump system
Hide thumbs Also See for ACiQ-24-AHB:

Advertisement

Quick Links

2023 V1.0
Thank you for purchasing a Next Gen Heat Pump system
from ACiQ. This system gives you the benefits of a variable
speed, inverter driven heat pump condenser, combined
This Quick Start Guide covers how to connect the thermostat to your system and ensure proper
communication. It is not meant to replace the entire installation manual. Please reference install
Quick Start Guide
ACiQ Next Gen
Ducted Heat Pump System
ACiQ-24-AHB/ACiQ-24-HPB
ACiQ-36-AHB/ACiQ-36-HPB
ACiQ-48-AHB/ACiQ-48-HPB
ACiQ-60-AHB/ACiQ-60-HPB
with a smart air handler with a variable speed blower.
manual for in depth instructions.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ACiQ-24-AHB and is the answer not in the manual?

Questions and answers

Summary of Contents for ACIQ ACiQ-24-AHB

  • Page 1 ACiQ-48-AHB/ACiQ-48-HPB ACiQ-60-AHB/ACiQ-60-HPB Thank you for purchasing a Next Gen Heat Pump system from ACiQ. This system gives you the benefits of a variable speed, inverter driven heat pump condenser, combined with a smart air handler with a variable speed blower.
  • Page 2 Option 1 - Wiring Diagram When Using Provided Thermostat (Recommended) ACiQ's provided thermostat will allow the system to operate at maximum efficiency and provide full programmability. Refer to the thermostat user's manual for detailed instructions. See below for quick start wiring guide.
  • Page 3 Option 2 - Connecting a 3rd Party 24 Volt Thermostat With Communication Wire Connected Any 24 volt thermostat can be selected. Select the appropriate profile from the options listed below to wire thermostat to air handler. S1 & S2 must be connected at the indoor unit and the outdoor unit. Set the system dip switches as shown below.
  • Page 4 Wiring For 2H and 2C - No Auxiliary Heat Grey = Unused Terminal Green = Used Terminal Diagram Grey = White Wire Thermostat Y/Y2 E/AUX Bottom CN10 CN11 Air Handler Data Transfer Circuit Board Wiring For 3H and 1C - Two Stage Auxiliary Heat W1/E Grey = Unused Terminal Green = Used Terminal...
  • Page 5 Default setting is OFF except S4. Please note if using the provided ACiQ thermostat DIP Switch Settings will not need to be adjusted. DIP Switch settings should only be adjusted by a professional HVAC service technician. Please note in this quick start guide the specific DIP Switches that need adjusted will be shown to ensure accurate operation for the chosen set up.

Table of Contents