ETI MULTI-FUNCTION THERMOMETER - Thermometer Manual

Table of Contents

Contents

1 INSTRUMENT OPERATION
2 HOLD
3 MAX/MIN
4 AUDIBLE ALARM
5 CALIBRATION FUNCTION
6 BATTERY REPLACEMENT
7 EMC/RFI
8 Documents / Resources
- 8.1 References
- 8.2 Download manual

INSTRUMENT OPERATION

Open the battery cover by gently pulling the foot stand to unravel the lead and insert the battery. The instrument is switched on by pressing the located on the front of the instrument. Remove the protective cover from the probe, Insert the probe into the substance being measured. The instrument reading may take a few seconds to stabilise, depending on the nature of the measurement.

HOLD

Press the Hold button to capture the temperature reading. The 'Hold' icon will flash in the display. Press the Hold button again to resume taking the temperature.

MAX/MIN

Press the MAX/MIN button to display the maximum reading (MAX symbol displayed). Press the MAX/MIN button again to display the minimum reading (MIN symbol displayed). Press MAX/MIN button again to return to normal readings. Hold MAX/MIN for three seconds to reset minimum and maximum temperature memory.
warning Please note: Max/Min readings are not saved so switching the thermometer off will clear the max/min readings.
°C/°F - Press and Hold the °C/°F button on the front of the instrument to switch between Centigrade and Fahrenheit.

AUDIBLE ALARM

Press the Set button and the 'HI' value will flash in the display. Press the up or down arrows to set the desired 'HI' alarm limit. Press the Set button again and the 'LO' value will flash in the display. Press the up or down arrows to set the desired 'LO' alarm limit. Press Set button again to set the alarm. The audible alarm will sound when the temperature setting has been exceeded. Press any button to stop the alarm sounding, the 'HI' or 'LO' symbol will continue to flash until the temperature is within the set limit. To disable (turn off) the Alarm/s, press the Set button and the 'HI' alarm digits will flash. Press the power button once and the display will show 'OFF', repeat for low alarm.

CALIBRATION FUNCTION

Press and hold the power button until 'CAL' is shown in the display. Using the and buttons, you can enter an offset temperature by as much as ±2.2°C/°F to compensate for any errors. Press the power button to return to the temperature display. If no buttons are pressed the screen will default to the temperature display after a short period of time.

BATTERY REPLACEMENT

Replace the battery when the display dims, using a AAA or 1.5 volt equivalent. The battery is located under the battery cover at the rear of the instrument, to change the battery lift the footstand and pull gently.

EMC/RFI

Instrument performance may be affected if operated within a high frequency radio field, such as near a mobile phone, or if subjected to an electrostatic shock.

Supplied by Electronic Temperature Instruments Ltd

Worthing · West Sussex · BN14 8HQ
01903 202151 · sales@etiltd.com • etiltd.com