Version; Time Setup; Nibp Setup; Temp Setup - EDAN M3 User Manual

M3 Vital Signs Monitor User Manual System Menu
Select YES to make the operation effective; select NO to cancel the operation.

4.6 Version

Select VERSION in SYSTEM MENU to check the version of the monitor and the configuration
of the modules.

4.7 Time Setup

Select TIME SETUP in SYSTEM MENU to access the submenu of TIME SETUP. System
time is in format of Y-M-D, M-D-Y or D-M-Y. Users can set the year, month, day, hour, minute
and second. Pick the item you want to modify and confirm it by pressing OK. Select EXIT item
to save the setup and return to the previous menu. If you want to exit the menu without saving it,
press the MENU on front panel.

4.8 NIBP Setup

Refer to 9.4 NIBP Setup.

4.9 TEMP Setup

Refer to 10.1.3 TEMP Setup for T2 Module and 10.3.7 TEMP Setup for F3000 Module.

4.10 Alarm Setup

Refer to 5.1.3 Alarm Setup.

4.11 Maintain

Select MAINTAIN item in SYSTEM MENU to open ENTER MAINTAIN PASSWORD
dialog box, in which you can enter password and then customize maintenance settings. Factory
maintenance function is only available for the service engineers of EDAN or representative
authorized by EDAN.
User Maintain
Input the user password 9 9 8 1 in the USER KEY box and press OK, USER MAINTAIN menu
will pop up, in which you can set following items.
BED No.: Set the bedside number to a value from 1 to 64.
LANGUAGE: Set the displayed language.
NOTE:
You should restart the monitor after changing the displayed language to make the
operation effective.
NURSE CALL: Turn on or off the nurse call. When the parameter alarm occurs, the monitor
gives 3s nurse call alarm prompt; if the audible alarm or the audio system is off, the monitor can
also give the nurse call alarm in abnormal condition.
The relay contact between pin7 and pin8 of RJ45 is normally open. But it is closed when an
alarm is audible.
SERVER IP: It can be changed by the user according to the IP of PC installed with MFM-CMS
- 31 -