Table of Contents
Advertisement
34
EN
Recording
Fea tures
C.RESET
Record O ne Progra m W hile
W a tching Another
EN GAGE TV MO DE
During recording...
1
● Press
TV/ VCR . The VCR's VCR indicator goes out. (If
you are using the RF connection (
the output from your VCR, the TV broadcast being
recorded disappears.)
● If you are using the AV connection (
the output from your VCR, change the TV's input
mode from AV to TV.
SELECT CHAN N EL FO R
VIEW IN G
Use the TV's channel selector to set the channel you
2
want to watch.
Downloaded from:
https://www.usersmanualguide.com/
PLAYBACK AN D RECO RD IN G FEATU RES (cont.)
1
2
3
2
4
5
6
7
8
9
0
4
1
pg. 6) to view
pg. 6) to view
Displa y Ela psed Recording
Time
RESET CO UN TER TO ZERO
Before recording starts, press C.RESET. The counter
1
resets to zero and displays the exact elapsed time as the
tape runs.
DISPLAY ELAPSED TIME O N
SCREEN
During recording, press O SD at any time to see the
2
D ISPLAY
elapsed time.
All indications corresponding to the current status of the
VCR are displayed for 5 seconds. The counter display
remains on the screen indicating the elapsed time.
Press O SD again to remove the display.
● Make sure "SUPERIMPOSE" is set to "ON" (
● The indications are not recorded.
● Press
Display Tape Remaining Time
DISPLAY CO UN TER
IN FO RMATIO N
Press O SD .
1
All indications corresponding to the VCR's current
status are displayed for 5 seconds. The counter display
remains on the screen indicating the elapsed time.
DISPLAY T APE REMAIN IN G
TIME
Press D ISPLAY until "REMAIN" appears on screen. The
2
approximate tape remaining time appears on the TV
screen and also on the VCR display panel with a "
indicator.
● The tape remaining time is calculated based on the
● Press
EXIT THE DISPLAY
Press O SD again.
3
N O TES:
● "SUPERIMPOSE" must be set to "ON", or the on-screen
display will not appear (
● Near the beginning of the tape, the tape remaining estimate
may be inaccurate. However, the estimate becomes more
accurate as the tape comes closer to the end.
● Depending on the type of tape used, the tape remaining time
reading may not appear right away, or may not be correct. "- -:- -"
may sometimes appear, or the display may blink on occasion.
● The tape remaining time indication is not accurate when using
VHS-C tapes with VHS-C adapter.
D ISPLAY to change to the COUNT display if
"REMAIN" is displayed.
tape speed (SP or EP) being used. The indicated
remaining time is only an estimate.
D ISPLAY to change the on-screen display from
REMAIN to COUNT and vice versa; and to show
counter reading, channel number, clock time or tape
remaining time on the front display panel. Then
channel number will not be displayed when the VCR
is playing a tape.
pg. 28).
pg. 28).
"
Advertisement
Table of Contents
