AEG CCE84543XB User Manual page 21

filter every 10-20 hours, or more
frequently, if needed.
• Regenerate the filter only when the
notification is on. The maximum
number of regeneration cycles is 7. After
that time, the filter needs to be replaced
with a new one.
The hob has a built-in counter with a
notification that reminds you about
regenerating the filter. The counter for the
notification starts automatically when you
turn on the hood for the first time. After
100 hours of use the filter indicator
starts blinking to signal that it is time to
regenerate the filter. The notification stays
on for 30 seconds after you deactivate the
hood and the hob. The notification does
not block the use of the hob.
WARNING!
An oversaturated filter can pose a risk of
fire.
Disassembling / reassembling the filter
The filter and filter housing are located right
under the grid in the centre of the hob.
Remove them carefully as they might be
slippery due to accumulated grease.
1. Remove the grid.
2. Take out the filter housing.
3. Gently push the two elements from the
outside in and fold them together. Then
take out the filter from the filter housing.
4. Reassemble the filtering unit after
cleaning:
a. Slide the filter elements inside the
filter housing along the built-in
runners. Make sure that the black
sides are facing inwards and the
silver sides are facing out. After
reassembling you should be able to
see the black side inside the cavity.
b. Place the filter housing back inside
the hood cavity.
Cleaning the filter housing
Wash the filter housing manually using a mild
detergent and a soft cloth. You can also wash
it in the dishwasher.
Cleaning the filter
1. Wash the filter in warm water without any
cleaning agents. Detergents can damage
the odour filtration. You can use a soft
sponge, a soft cloth, or a non-abrasive
cleaning brush to remove food remains, if
necessary. You can also wash the filter in
a dishwasher at 65-70 °C (using a
program longer than 90 min), without
detergents and without dishes in the
same load.
ENGLISH 21