Netware - Compaq DLT User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing the Software Drivers
4-2

NetWare

Drivers for the SCSI controller and tape drive hardware are located on the
Support Software Diskette or CD. The Support Software ships with each server
or can be obtained on the Compaq Forum of CompuServe or QuickFind. Refer
to Appendix C for more information on the Compaq Forum. The software tape
device driver is located either with your tape backup software or with the
operating system. Refer to your backup software application installation guide
for more information regarding additional software that might be needed
32-Bit Fast-SCSI-2 Controllers (15/30 DLT
Drive only)
and
32-Bit Fast-Wide SCSI-2 Controllers
and
Wide-Ultra SCSI Controllers
If you are using one of the 32-Bit Fast SCSI-2 Controllers, the controller driver
is CPQS710.DSK. This driver must be loaded on the server before installing
the software for the tape drive.
Writer: Jim Belew Project: Installing the Software Drivers Comments: 185292.002 final
Controller
G-CH4.DOC
File Name: Last Saved On:
Table 4-1
NetWare
Software Driver Installation
Run the README.COM file on any of the
Novell Software Support Diskettes
(NSSD) for driver installation
instructions.
3/13/97 7:35 AM
.