Table of Contents
Advertisement
Section 2
The Model SB25 is a commercial combination ice
shaver/blender machine equipped with metered water
dispensing, available in 115V 60 Hz or 220/240V 50 Hz.
The 115V 60 Hz machine is also equipped with optional
metered liquid sugar cane dispensing.
The Rinse Station is a machine designed as an
accessory to the SB25 ice shaver/blender machine. It is a
timer controlled, automatic system that rinses the interior
of the blender pitchers.
The machine you have purchased has been carefully
engineered and manufactured to give you dependable
operation. When this machine, is properly operated and
cared for, it will produce a consistent quality product. Like
all mechanical products, it will require cleaning and
maintenance. A minimum amount of care and attention is
necessary if the operating procedures outlined in this
manual are followed closely.
IMPORTANT! This manual should be read
before operating or performing any maintenance on the
machine.
Your Taylor machine will NOT compensate for and/or
correct any errors made during setup or filling operations.
Thus, the initial assembly, setup, and priming procedures
are of extreme importance. It is strongly recommended
that all personnel responsible for the machine's
operation, including assembly and disassembly, go
through these procedures together to be properly trained
and to make sure that all personnel understand their role
in using and maintaining the machine.
If you require technical assistance, please contact your
local authorized Taylor distributor.
To the Operator
To the Operator
Note: Your Taylor warranty is valid only if the parts are
authorized Taylor parts, purchased from the local
authorized Taylor distributor, and only if all required
service work is provided by an authorized Taylor service
technician. Taylor reserves the right to deny warranty
claims on machines or parts if parts not approved by
Taylor or incorrect refrigerant were installed in the
machine, system modifications were performed beyond
factory recommendations, or it is determined that the
failure was caused by abuse, misuse, neglect, or failure
to follow all operating instructions. For full details of your
Taylor Warranty, please see the Limited Warranty section
in this manual.
IMPORTANT! If the crossed-out wheeled bin
symbol is affixed to this machine, it signifies that this
machine is compliant with the EU directives as well as
other similar end-of-life legislation in effect after August
13, 2005. Therefore, it must be collected separately after
its use is completed and cannot be disposed as unsorted
municipal waste.
The user is responsible for delivering the machine to the
appropriate collection facility as specified by your local
code.
For additional information regarding applicable local
disposal laws, please contact the municipal waste facility
and/or local authorized Taylor distributor.
Note: Constant research results in steady
improvements; therefore, information in this manual is
subject to change without notice.
Model SB25
2
2-1
Advertisement
Table of Contents
