Table of Contents
Advertisement
Section 1
The following information has been included in the
manual as safety and regulatory guidelines. For complete
installation instructions, please see the Installation
Checklist.
Installer Safety
IMPORTANT! In all areas of the world,
machines should be installed in accordance with existing
local codes. Please contact your local authorities if you
have any questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and service
®
of Taylor
machines.
•
Only Taylor service personnel should perform
installation, maintenance, and repairs on Taylor
machines.
•
Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for industry
standards on lockout/tagout procedures before
beginning any installation or repairs.
•
Authorized service personnel must ensure that
the proper personal protective equipment (PPE)
is available and worn when required during
installation and service.
•
Authorized service personnel must remove all
metal jewelry, rings, and watches before
working on electrical equipment.
DANGER! The main power supply(s) to the
machine must be disconnected prior to performing any
installation, maintenance, or repairs. Failure to follow this
instruction may result in personal injury or death from
electrical shock or hazardous moving parts, as well as
poor performance or damage to the machine.
WARNING! This machine has many sharp
edges that can cause severe injuries.
To the Installer
Site Preparation
Review the area where the machine will be installed
before uncrating the machine. Make sure that all possible
hazards to the installer, user, and the machine have been
addressed.
For Indoor Use Only: This machine is designed to
operate indoors, under normal ambient temperatures of
70°F to 75°F (21°C to 24°C). The machine has
successfully performed in high ambient temperatures of
up to
104°F (40°C) at reduced capacities.
WARNING! This machine must NOT be
installed in an area where a water jet or hose can be
used. NEVER use a water jet or hose to rinse or clean
the machine. Failure to follow this instruction may result
in electrocution.
CAUTION! This machine must be installed on
a level surface to avoid the hazard of tipping. Extreme
care should be taken in moving this machine for any
reason. Two or more people are required to safely move
this machine. Failure to comply may result in personal
injury or equipment damage.
Before moving the machine:
•
Unplug the (2) power cords from wall.
•
Disconnect the (2) water lines from the back of
the machine.
•
Disconnect the cane pump line from the back of
machine (115V 60 Hz machines only).
The authorized installer should inspect the machine for
damage and promptly report any damage to the local
authorized Taylor distributor.
This machine is made using USA sizes of hardware. All
metric conversions are approximate.
IMPORTANT! Install potable water connection
with a water filter and adequate backflow protection to
Model SB25
To the Installer
1
1-1
Advertisement
Table of Contents
