Table of Contents
Advertisement
7 | Assembling the Parts
Notice
Notice
22 / 60
7.6
Gyro/Acceleration Sensor
The gyro/acceleration sensor is specific to the system and should be mounted as
close as possible to the center of gravity of vehicle. The sensor should be assem‐
bled with the supplied damping plate. Position the sensor so that the connector
is pointing towards the rear of the vehicle.
Only use the provided kit sensor.
Use the damping plate.
Make sure the sensor is facing the correct direction (see image
above).
For more on assembly: See the Offer Drawing: Gyro/Acceleration
Sensor
[}
51].
7.7
ABS Map Switch
While driving, the driver can use the ABS map switch to select different control
settings and find the optimum setting for his/her driving style. For this reason,
make sure the switch is mounted within reach of the driver. Many have found it
helpful to fit a diagram showing the current switch position, see also diagram on
Features
[}
6]. The switch position is also broadcast on the CAN Bus so it can be
displayed with a dash (e. g. the DDU 7 from Bosch Motorsport).
Only use the supplied ABS Map Switch.
Don´t exceed the max. tightening torque of 1-2 Nm. Higher
torque will cause stiffness and damage.
7.8
ABS warning light (MIL)
Light bulb
LED
ABS M4 Manual
Front-panel cut
Bosch Motorsport
Advertisement
Table of Contents
