Output Solutions EZ-2P Programmer's Manual page 33

Guillotine Cutter Adjustment
1. There is an adjustable showed as arrow "A" on the left side of cutter.
2. The paper jam may cause the cutter work improperly, please power off the printer.
3. Use T type screw driver insert into the opening "A" and turn clockwise. The blade of cutter
should be opened, remove the paper inside the cuter.
4. After the paper jam problem is eliminated, power on the printer, at this moment, the cutter
will regress automatically to cutting position.
Rotary Cutter Adjustment
1. There are two adjustable opening showed as arrow "A" on the cutter.
2. The paper jam may cause the cutter work improperly, power off the printer.
3. Use #M3 Hex Key insert into the opening "A" and turn clockwise. The blade of cutter should
be opened, then remove the paper inside the cutter.
4. After the paper jam problem is eliminated, power on the printer, at this moment, the cutter
will regress automatically to cutting position.
A
32
A