Output Solutions CP-8 User Manual

Output solutions cp-8: user guide

Advertisement

Quick Links

USER'S MANUAL V1.2
USER'S MANUAL
Page 1/10

Advertisement

Table of Contents
loading

Summary of Contents for Output Solutions CP-8

  • Page 1 USER’S MANUAL V1.2 USER’S MANUAL Page 1/10...
  • Page 2 FCC Radio Frequency Interference Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 3: Table Of Contents

    ONNECT THE POWER SUPPLY CD-ROM ...6 SE OF THE 3.3.1 Opreating system ... 6 3.3.2 Autorun ... 6 3.3.3 CD-ROM contents... 6 PRINTER USE... 7 ...7 HE LEDS ...7 PRINTING MODES HOW TO PLACE A RIBBON ...7 ...9 ARD INSERTION ...9 EMOVE THE RIBBON WARNINGS ...
  • Page 4: Introduction

    1. INTRODUCTION Contents of the package : • A Quick Start sheet • A printer • A power supply with its power cord • A CDROM • A serial cable 2. CHARACTERISTICS Resolution : 300 dpi Printing technologies : Thermal transfert...
  • Page 5: Installation

    THE PRODUCT SAFETY IS WARRANTED ONLY WHEN USED WITH THE EXTERNAL POWER SUPPLY DELIVERED WITH THE PRINTER The wall plug must be easily accessible and close to the printer. The product safety is only warranted with standart power connector (NFC15-100 or CEI364).
  • Page 6: Use Of The Cd-Rom

    The printer power ON / OFF is done by plugging / unplugging the jack connector. 3.3 Use of the CD-ROM Warning : the supplier assumes no responsibility for any damage, liability or other loss resulting from the use of these CD-ROM.
  • Page 7: Printer Use

    4.1 The leds GREEN ORANGE When you switch on the printer, if the green led is OFF and the orange led is ON your printer is in the boot mode (contact your technical support). 4.2 The 3 printing modes With the Windows driver you can select 3 printing modes: •...
  • Page 8 USER’S MANUAL V1.2 • close the printer • the printer is now ready to print • Put the full reel on the right side • Put the empty reel on the left side by sliding the ribbon under the printer •...
  • Page 9: Card Insertion

    Push until the roll takes it • Wait until end printing • If you insert a card and remove it, the printer will go to error state • If you do not insert a card enought to be taken by the roll, after a timeout the printer will go to error state •...
  • Page 10: Warnings

    Cleanning the print header : see Maintenance/tools menu on the CDROM • Cleanning the outside of the printer : do not use volatile solvents such as alcohol, paint thinner, gasoline, benzine, etc. Use only a clean dry cloth USER’S MANUAL V1.2 •...

Table of Contents