Table of Contents
Advertisement
Description
Graphics download to external flash card/ internal memory
Additional function: : If download name already exists, the printer will printout message
Format download to external flash card
Additional function: If download name already exists, the printer will printout message " FORM
NAME ALREADY EXIST" and download is not allowed.
RTC setting
The year sets from 1990 to 2089.
3. Revised function
Self Test
The self-test function helps you check if the printer works well. To get in the self-test function;
please follow the steps.
1.
Hold down the feed button when powering on.
2.
Release the feed button after the printer beeps 4 times.
3.
Wait about 3 seconds, the printer will printout contain of the self-test.
Check mode
To get in the check mode; please take the following steps.
1.
Hold down the feed button when powering on.
2.
Continue to hold down the feed button. The printer will beep 4 times and print out a blank
label of 19cm long. When the printer stops, release the feed button.
3.
The printer will print the following contents.
CHECK MODE BEGIN
Note:
Disable the Check mode or Self-test, please power off the printer at least 2
seconds, than power on again.
Stripper operation
The first time to use strip function, the printer will send a blank label and printout very slowly.
After pick up the label, the printer printout will normally.
Install the Strip Bracket Bar
The strip bracket bar was use for strip function. If you don't need to use strip function, you may
take out the strip bracket bar and keep to safe place. Please follow these steps to install the
strip bracket bar.
1. Refer the figure 1 to setup the strip bracket bar to the right position.
2. Refer the figure 2, follow the 3-arrow position and direction to gently insert the strip bracket
bar until hear the click sound.
3. Refer the figure 2, a part of zoom out to show the strip bracket bar correct position. Please
check whether the strip bracket bar was setup correct.
value: inc. / dec. value of serial variable (up to 12-digit)
prompt: prompt of serial variable (up to 20 characters)
: Set the serial number. An object allows at most 3 serial numbers.
Ex. AC,5,5,1,1,1,0,^C0^C1^C2
" GRAPHICS NAME ALREADY EXIST" and download is not allowed.
28
Advertisement
Table of Contents
