Output Solutions CP-1002 SERIES Owner's Manual page 27

2. Lift the Media Holder and put it on top of the Media Holder Unit by fitting its stud into the hole.
Media Holder
Media Holder Unit
3. Place the stack of card between the Media Guides and put the Media Holder on the card stack.
Push the card stack against the printer until it stops.
Upper Limit Line of
Business Card/Post Card
NOTES:
1. Be sure to place the cards so that the print side faces up and the shorter side becomes the leading
edge, as shown in the above diagram.
2. Do not stack the cards exceeding the upper limit line.
3. In case of 0.22 mm thick media, 300 pieces can be set at the same time. As the media becomes
thicker, the number of media that can be set becomes fewer.
4. Push the Media Guides by the "Press" sign to the centre and fit them to the edges of the card
stack. Then, tighten the two Media Guide Fixing Screws to secure the Media Guides.
Media Guide
Media Guide Fixing Screw
Media Guide
Media Holder
Stack of Card
Media Guide Fixing Screw
27