Pentair STA-RITE INTELLIFLO3 Install Manual page 2

Installing the Touchscreen Controller
1. Verify the Button Gasket is correctly
installed onto the Touchscreen
Controller (as shown in FIGURE 2A).
If Button Gasket is NOT properly
installed, Align the gasket as shown in
FIGURE 2B.
2. Align and place the Touchscreen
Controller onto the Drive Assembly as
shown in FIGURE 3.
3. Gently push the Touchscreen Controller
down until it is flush with the top of the
Drive Assembly.
4. Using the four provided Touchscreen
Screws (3), secure the Touchscreen
Controller to the Drive Assembly. See
FIGURE 3.
5. Reinstall the Wiring Cover.
6. Close the Touchscreen Cover when not
in use to protect the screen.
7. Refer to your pump's Installation and
Maintenance Guide (P/N 356231) for
instructions on restarting your filtration
system and using the Touchscreen
Controller.
1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000
10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000
WWW.PENTAIR.COM
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and
logos are the property of their respective owners. Because we are continuously improving our products and services, Pentair
reserves the right to change specifications without prior notice.
© 2021 Pentair. All rights reserved. This document is subject to change without notice.
*356234*
P/N 356234 REV. A 10/18/21
A
FIGURE 2
FIGURE 3
4
B
3
3