Installation Settings - Robertshaw RS8110 Operation Manual

INSTALLATION SETTINGS

Select OFF with the system switch, hold down the + and - buttons together
for 3 seconds to access the CALIBRATION setting. Use the + to adjust the
temperature from -4°F to +4°F.
Then press - to access the F(Fahrenheit) or C(Celsius) setting, use + to
select.
Press - again to access the DELAY selection, the compressor delay will not
allow the compressor to be turned on for 5 minutes after the last time the
compressor was on. Use the + to select ON or OFF (ON: the Y terminals will
turn off for at least 3 minutes). Wait approximately 15 seconds or slide the
system switch to return to normal operation.
8