Advertisement
To insert a cam lock:
Note:
·
Read these instructions carefully before assembling.
·
Tools required : Phillips screwdriver, flat screwdriver.
·
Find a clean, smooth area on which to work , such as a carpet, in order to avoid scratching the wood
surfaces.
·
Wait to dispose of the packing material until assembly is complete and all parts and hardware are
accounted for.
·
Two or more people might be required for assembly.
(Please read below instructions before assembling)
Diagram A
1. Insert cam screw into hole as shown in diagram A .
Diagram B
Diagram C
ARROW SIGN
SCREWDRIVER TO TIGHTEN CAM LOCKS.
Make sure not to insert the cam screw:
Too deep as shown in figure B as this will cause the
cam screw to be misaligned and unable to
interlock properly.
Also avoid inserting the cam screw too close to the
surface of the hole as shown in figure C, as this will
cause the cam lock to be too loose, and not interlock
properly.
2. Connect the panels together.
3. When inserting the cam lock make sure the arrow
of the cam lock faces the cam screw.
4. To tighten the cam lock turn the cam lock clockwise
90-180 degree or until the arrow is facing opposite
the place cam lock was inserted.
NOTE: DO NOT USE AN AUTOMATIC
Page 2 of 11
Advertisement
