Table of Contents
Advertisement
8.2. Description of work
Connect the flow sensors, and configure them by going to the menu with the
buttons "C1" and "C2".
Press the "Start" ("Enter") button and the measurement will begin. At the
same time, the button will blink.
To reset the average flow, press the "R1" or "R2" button. To turn off the
measurement, press the "Start" button again. If the message is displayed when
starting the measurement:
this means that 500 liters of fluid have passed through the filter and need to be
cleaned. The current volume can be viewed in the "Filter" item. To reset it, hold
down the "Start" button. The message can be ignored by pressing the "Start" button
again, but it will appear each time the measurement is started.
10
CPFM-Tester
Advertisement
Table of Contents
Need help?
Do you have a question about the CPFM-Tester and is the answer not in the manual?
Questions and answers