Haier HWT12AD1 User Manual page 22

Operation and Wash Cycles
Display should show boot when OTA update enters the bootloader mode. It may
show ERAS during the OTA erasing flash memories and may show counting time in
seconds during the OTA writing flash memories.
boot will show on the screen when
OTA enters bootloader mode.
The screen may show counting 'time' in seconds
during the OTA writing flash memories
BEEP AND WARNING TONES
Turning the machine ON/OFF will make 1 beep sound.
Every time a button is pressed or the dial is turned it will sound 1 beep tone.
Any time a multi-key press (Child Lock and Favourite) is successful it will make 1 beep tone.
STARTING the wash process and PAUSING also make 1 beep tone.
3 Warning tones will occur when modifier buttons are pressed when they are not allowed
to change at that time.
Once the wash cycle has started, turning the dial in any direction will make 3
warning beeps.
If the machine has the CHILD LOCK active then pressing any button or turning the dial with
make 3 warning tones.
If an error occurs, the machine will beep 3 times - every 10 seconds to
indicate the error so that the user can address the problem. Pressing any button will stop
the beeping tone, but the error code will stay until resolved.
FACTORY RESET
As users can save a variety of FAVOURITES , this will clear all favourites saved by the user.
To reset the machine to factory settings: press the Water Temp and Options together，
then press the Power button, FS will display on the screen for 3 seconds and the product
will beep 5 times.
19
20