Table of Contents
Advertisement
Available languages
Available languages
- WARNING: In order to avoid overheating, do not cover the heater.
- The heater must not be located immediately below a socket-outlet.
- The heater must be installed at least 1.8 m above the floor
- Means for disconnection having a contact separation in all poles must be
incorporated in the fixed wiring in accordance with the wiring rules.
Installation:
Drill two holes in wall and have a distance of 1.8m from the ground. The diameter of the hole just
contained the inflated plastic pipe. After tucked the inflated plastic pipe, fixed pothook on the pipe with
screw. Make sure pothook fastness and hang the heater. The clip under the pothook should be inserted
rabbet of the heater bottom.
Function operation (both control panel& remote control)
ON-OFF
- Press the ON -OFF switch to switch the appliance ON (I) or OFF (O).
=Power
=Mode selection
= Heating on half power (1000W)
= Heating on full power (2000W)
P = Weekly programming
=Open window Mode
°C = Setting temperature
= Timer (Turn-on/Turn-off)
Stand-by mode
Regular function operation
Temperature setting and ErP function
confirm
Weekly
detection operation
.
time
&
window
open
Advertisement
Table of Contents
