Specific Safety Rules - Flexlite FLX3M Operator's Manual

SPECIFIC SAFETY RULES

Know your worklight. Read operator's manual carefully.
Learn its applications and limitations, as well as the
specific potential hazards related to this worklight.
Following this rule will reduce the risk of electric shock, fire,
or serious injury.
Lens and housing become hot during use:
During or immediately after use, don't lay worklight flat
on lens surface or place lens area in contact with a plastic
or fabric covered surface.
Handle worklight with care around any flammable surface.
Do not use or permit use of worklight in bed or sleeping
bags. This worklight lens can melt fabric and a burn injury
could result.
Do not disassemble your worklight.
Do not permit children to use worklight unsupervised. It
is not a toy. The temperature of the light head will become
hot after being on for only a short period of time. This hot
temperature can cause burn injury if touched and can create
sufficient heat to melt some fabrics.
Stay alert. Watch what you are doing and use common
sense. Do not rush.
If wrapped or in contact with fabrics, the worklight lens
can produce sufficient heat to melt some fabrics. To avoid
serious personal injury, never allow the worklight lens to
come in contact with anything.
Check damaged parts. Before further use of this worklight,
a part that is damaged should be carefully checked to
determine that it will operate properly and perform its
intended function. Do not use worklight if it does not
function properly.
WARNING!
LED LIGHT
Do not stare into the beam or view directly with or without optical instruments.
WARNING!
Do not project the light toward a road, another person or any vehicle to prevent blindness. Doing so, may result in serious
injuries or death.
Do not abuse the cord. Never use the cord to carry the
FLEXLITE. Do not pull the cord rather than the plug when
disconnecting from receptacle. Damage to the cord could
occur and create an electric shock hazard. Replace damaged
cords immediately.
Make sure the cord is located so that it will not be
stepped on, tripped over, come in contact with sharp
edges or moving parts or otherwise subjected to damage
or stress. This will reduce the risk of accidental falls, which
could cause injury, and damage to the cord, which could
result in electric shock.
Keep the cord from heat to prevent damage to housing or
internal parts.
Do not let gasoline, oils, petroleum-based products, etc.
come in contact with plastic parts. They contain chemicals
that can damage, weaken, or destroy plastic.
An extension cord should not be used unless absolutely
necessary. Use of an improper extension cord could result in
a risk of fire and electric shock. If extension cord must be
used, make sure:
That extension cord is properly wired and in good
electrical condition; and
That wire size is large enough for AC ampere rating of
FLEXLITE as specified below:
Cord Length (Feet)
Cord Size (AWG)
NOTE: AWG = American Wire Gauge
25´ 50´ 100´
16 16 16
3