INSTALLING AND CHARGING THE BATTERIES
The camera's battery can be charged in a variety of ways:
A. Through the camera itself by connecting the AC adaptor through
B. By docking the camera into a PV100D cradle and connecting
C. By taking out the battery from the camera and inserting into the
NOTE: It takes approximately 6 hours to fully charge the Li-Ion
battery. The right LED (Refer to P.2) showing red means the camera is
being charged. When the battery is fully charged, the right LED turns off.
NOTE: In a non-controlled environment, many factors can affect battery
life such as temperature, use of the flash, photo review, LCD display
brightness levels and so on.
ATTACHING THE STRAP
PV100 Eng R7 a OP
the PV100's DC jack.
the AC adaptor through the DC jack.
battery slot of the cradle for charging.
1. Pass the thin loop of the strap through
2. Pass the other end of the strap through
3. Tighten by pulling the loop.
5
Your camera comes with a
rechargeable Lithium-Ion
(Li-Ion) battery. To prevent
damage, correctly insert the
battery as shown.
T I P : To m a x i m i z e t h e
performance of your camera
and for greater battery life,
control the use of the flash,
photo review, and LCD
brightness levels.
the camera's strap ring.
the loop.
4
9/9/04, 2:45 PM