Plc Configuration List - Xinje XG Series User Manual

※
2
CNT Single phase high speed counting
※
2
CNT_AB AB phase high speed counting
※
2
CNT Single-phase 100 segments high speed
counter(with interruption)
COLR MODBUS coil read
INPR MODBUS input coil read
COLW MODBUS single coil write
MCLW MODBUS multi coil write
SEND Free format communication sending
data
CFGCR Reading of serial port parameters
※
2
STR Precise timing
※
1
DMOV Read precise timing register
EI Enable interrupt
DI Disable interrupt
SBSTOP BLOCK stop
SBGOON Carry on the suspensive BLOCK
TO Write module /BD data
※
1
PWM Pulse width modulation
PID PID operation control
Note:
※1: the instruction marked with ※1 is a 32-bit instruction, and does not have a 16-bit instruction form.
Other instructions are 16 bits.
※2: the table does not contain X-NET and Ethernet communication instructions. Please refer to the user
manual of X-NET bus and the user manual of TCP IP communication based on Ethernet.
Appendix 3. PLC configuration list
This part is mainly for the convenience of users to check the function configuration of various series models.
Through this table, it is easy to judge the selection of product models.
For a detailed description of the following functions, please refer to the user manual of XG series PLC [basic
instructions] and [positioning control].
RST
※
2
DMOV
High speed counter interrupt
※
CNT_AB
Communication
REGR
INRR
REGW
MRGW
RCV
CFGCW
Precise timing
STOP
Interrupt
IRET
BLOCK
WAIT
FROM
Other
FRQM
NAME_C
Reset high speed counter
Read write high speed counter
2
AB-phase 100 segments high speed
counter(with interruption)
MODBUS register read
MODBUS input register read
MODBUS single register write
MODBUS multi register write
Free format communication receiving
data
Writing serial port parameters
Stop precise timing
Interrupt return
Wait
Read module /BD data
Frequency measurement
C function block
65