Table of Contents
Advertisement
About this task
The following image(s) indicate the location of the headset port and provides a visual representation of the installation procedure.
Steps
1. Align the headset port into the slot on the palm-rest and keyboard assembly.
2. Route the headset port cable through the slot on the palm-rest and keyboard assembly.
3. Align the screw holes on the headset port to the screw holes on the palm-rest and keyboard assembly.
4. Replace the screw (M1.6x3) that secures the headset port to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure from step 5 to step 19 in
NOTE: The system board can be removed and installed along with the heat sink. This simplifies the removal and installation
procedure and avoids breaking the thermal bond between the system board and heat sink.
2. Install the
M.2 2230 solid-state drive
3. Install the
wireless
card.
4. Install the
rear
I/O-cover.
5. Install the battery.
6. Install the
base
cover.
7. Follow the procedure in
Fan and heat-sink assembly
Removing the fan and heat-sink assembly
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
wireless
card.
5. Remove the
M.2 2230 solid-state drive
6. Remove the
rear
I/O-cover.
Replacing the system
or
M.2 2280 solid-state
After working inside your
Before working inside your
or
M.2 2280 solid-state
board.
drive, as applicable.
computer.
computer.
drive, as applicable.
49
Advertisement
Table of Contents
