Solid-State Drive - Alienware x14 R2 Service Manual

Steps
1. Align and place the left and right antennas on the slot on the palm-rest and keyboard assembly.
2. Replace the four screws (M1.6x3) that secures the left and right antennas to the palm-rest and keyboard assembly.
3. Route the antenna cables onto the routing guides on the palm-rest and keyboard assembly.
4. Adhere the tape that secures the antenna cables to the palm-rest and keyboard assembly.
Next steps
1. Install the speakers.
2. Install the wireless card.
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in

Solid-state drive

Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the base cover.
About this task
NOTE: The following procedure applies only to computers shipped with an M.2 2230 solid-state drive.
NOTE: The M.2 card installed on M.2 slot will depend on the configuration ordered. Supported card configurations:
After working inside your
Before working inside your
computer.
computer.
27