Related Manuals for CleanCraft SCWP 7514
Summary of Contents for CleanCraft SCWP 7514
- Page 1 Operating Instructions Water pump SCWP 7514, SCWP 10013 SDWP 7514, SDWP 10020 SPWP 1106A, SPWP 1107 SPWP 1106A SCWP 10013 SCWP 7514 SDWP 7514 SDWP 10020 SPWP 1107...
-
Page 2: Table Of Contents
Contents 1 Introduction .............3 Product identification 1.1 Copyright ............3 1.2 Customer service..........3 Water pump Item number 1.3 Limitation of liability ..........3 SCWP 7514 7520100 2 Safety................3 SCWP 10013 7520105 2.1 Symbol explanation ..........3 SDWP 7514 7520200 2.2 Obligations of the operating company .... -
Page 3: Introduction
1.3 Limitation of liability You have made a good choice by purchasing the All information and notes in these operating instructions CLEANCRAFT water pump. were summarised while taking applicable standards and rules, the state-of-the-art technology and our long- Read the operating manual thoroughly before commis- term knowledge and experiences into consideration. -
Page 4: Obligations Of The Operating Company
Safety lations valid for the area of application of the machine must be observed. The following applies in particular: WARNING! This combination of symbol and signal words indi- - The operating company must be informed about the cates a potentially dangerous situation which may applying industrial safety regulations and further an- lead to death or severe injury if not avoided. -
Page 5: Personal Protective Equipment
Safety Only persons reliable working procedures can be ex- pected from, are allowed to perform all works. Persons Protective gloves the responsiveness of which is affected by e. g. drugs, alcohol or medication, are not allowed to work with the The protective gloves serve to protect the hands against sharp components as well as against fric- machine. -
Page 6: Safety Labels On The Water Pump
Safety - Only touch the pump if it has been switched off for at least 5 minutes. ATTENTION! - Only dismantle the pump body with the pump After the device has been tipped over, it is recom- switched off and the pump chamber empty. mended to set it up again and then switch it off. -
Page 7: Intended Use
Intended use 3.2 Residual risks Even if all safety regulations are observed and the The submersible pumps SCWP 7514, SCWP 10013 and water pump is used according to the instructions, there the submersible pressure pump SPWP 1107 are suita- are still residual risks, which are listed below: ble for pumping clean water. -
Page 8: Technical Data
Technical Data Technical Data Model SCWP 7514 SCWP 10013 SDWP 7514 SDWP 10020 SPWP 1106A SPWP 1107 Length 174 mm 183,5 mm 187 mm Width / Depth 159 mm 151 mm 159 mm 157 mm 168 mm 163 mm Height... -
Page 9: Transport, Packaging, Storage
Transport, packaging, storage Device description 6.1 Delivery Submersible water pump SCWP 7514: Check the water pump on delivery for any visible trans- portation damage. If you notice any damage to the de- vice please report this immediately to the carrier or dealer. - Page 10 Device description Combination submersible pump SDWP 7514: Submersible pressure pump SPWP 1106A: Fig. 5: Description SDWP 7514 1 Handle 2 Upper cover 3 Pump body 4 Outflow connection 5 Outflow elbow 6 Baseplate Fig. 7: Description SPWP 1106A 7 Cable hook Submersible pressure pump SPWP 1107: 8 Power cable 9 Float switch...
-
Page 11: Operation And Function
1 in Fig.8. When the water level drops, the float switch turns off and the electric pump shuts off automat- ically. Fig. 10: Correct lifting or mounting of a rope SCWP 7514 Water Pumps | Version 1.05... - Page 12 Device description ATTENTION! The water quality may change due to the non-toxic oil in the sealing device. Adjustment of the combo function on the model SDWP 7514: In the combination version, the foot position can be ad- justed to change the working status of the pump. Change of water mode from clear to dirty water: Step 1: Turn the electric pump so that the floor is facing you (Fig.13).
-
Page 13: Installation
Installation Installation 8.2 Electrical connection 8.1 Notes on installation The device has a power cord with mains plug: - The mains connection cable and plug may only be replaced by qualified personnel to avoid hazards. ATTENTION! - Never pull the power supply cable out of the socket When installing the unit, make sure that the motor is by the cable, but always by the power plug. -
Page 14: Start-Up
10 Operation ATTENTION! GEFAHR! Submersible water pumps SCWP 7514, SCWP 10013 and Danger to life due to electric shock! submersible pressure pump SPWP 1107: Make sure that only fresh water can be pumped with the water Before each use, check the pump, especially the pump. -
Page 15: Starting The Water Pump
Operation e mit Wasser füllen ATTENTION! NOTE! Always disconnect the power plug from the socket When starting up the pump for the first time, it is before handling the switched off water pump. essential to ensure that the pump housing is com- pletely vented, including self-priming pumps. -
Page 16: Care, Maintenance And Repair
Care, maintenance and repair 11.1 Care by cleaning Model SPWP 1106A The pump is equipped with a pressure sensor and a The water pump must always be kept in a clean condition. flow sensor so that the pump can start and stop automa- tically. -
Page 17: Disposal, Recycling Of Used Devices
In case of doubt, please pump yourself, then please contact your nearest contact your local waste disposal service. CLEANCRAFT dealer. Please write down the follow- ing information from the water pump or the operating If necessary, use the services of a specialized waste instructions in advance to help you with your problem disposal company for processing. - Page 18 Disturbances, possible causes and measures Troubleshooting Malfunction Possible cause Solution The pump works, but A. The suction grille is clogged. A. Clean the suction filter. does not deliver water. B. The impeller is clogged. B. Remove the blockage or change the impeller. C.
-
Page 19: Spare Parts
Spare parts 14 Spare parts Example The stator housing for the water pump SCWP 7514 must DANGER! be ordered. The stator housing has the number 38 in the Danger of injury by the use of wrong spare spare parts drawing 1. -
Page 20: Spare Parts Drawing
Spare parts 14.2 Spare parts drawing In case of service, the following drawing shall help to identify the necessary spare parts. Spare parts drawing Model SCWP 7514 Fig. 14: Spare parts drawing Model SCWP 7514 Water Pumps | Version 1.05... - Page 21 Spare parts Spare parts drawing Model SCWP 10013 Fig. 15: Spare parts drawing Model SCWP 10013 Water Pumps | Version 1.05...
- Page 22 Spare parts Spare parts drawing Model SDWP 7514 Fig. 16: Spare parts drawing Model SDWP 7514 Water Pumps | Version 1.05...
- Page 23 Spare parts Spare parts drawing Model SDWP 10020 Fig. 17: Spare parts drawing Model SDWP 10020 Water Pumps | Version 1.05...
- Page 24 Spare parts Spare parts drawing Model SPWP 1106A Fig. 18: Spare parts drawing Model SPWP 1106A Water Pumps | Version 1.05...
- Page 25 Spare parts Spare parts drawing Model SPWP 1107 Fig. 19: Spare parts drawing Model SPWP 1107 Water Pumps | Version 1.05...
-
Page 26: Electrical Wiring Diagram
Electrical wiring diagram 15 Electrical wiring diagram Fig. 20: Electrical wiring diagram Water Pumps | Version 1.05... -
Page 27: Declaration Of Conformity
Manufacturer / distributor: Dr.-Robert-Pfleger-Str. 26 D-96103 Hallstadt hereby declares that the following product Product group: Cleancraft® Sauggeräte Machine type: Water pump Designation of the machine*: Item number: SCWP 7514 7520100 SCWP 10013 7520105 SDWP 7514 7520200 SDWP 10020 7520205 SPWP 1106A 7520305... - Page 28 www.cleancraft.de...
Need help?
Do you have a question about the SCWP 7514 and is the answer not in the manual?
Questions and answers