14 Spare Parts ............18 Germany. 14.1 Ordering spare parts........18 14.2 Spare Parts Drawing GP 1105 C....19 The contents of these operating instructions are the sole 14.3 Spare Parts Drawing GP 1105 P ....20 property of the company Stürmer.Passing on as well as 14.4 Spare Parts Drawing GP 1105 S ....
1.3 Limitation of liability You have made a good choice by purchasing the All information and notes in these operating instructions CLEANCRAFT garden pump. were summarised while taking applicable standards and rules, the state-of-the-art technology and our long-term Read the operating manual thoroughly before com- knowledge and experiences into consideration.
Safety 2.2 Obligations of the operating company CAUTION! The operating company is the person who operates the This combination of symbol and signal words indica- water pump for business or commercial reasons by her- tes a potentially dangerous situation which may lead self, or leaves it to a third party for use or ap-plication, to slight or minor injury if not avoided.
Safety 2.3 Requirements to staff 2.4 Personal protective equipment The personal protective equipment serves to protect per- The different tasks described in this manual represent sons against impairments of safety and health while wor- different requirements to the qualification of the persons king.
Page 6
Safety - Eliminate disturbances that affect safety immediately. ATTENTION! - Before each use, make sure that no parts are damaged on the water pump.Damaged parts must be replaced Do not pump salt water with the pump! immediately to avoid danger sources. - Do not overload the water pump! You work better and safer in the specified performance range.
Intended use 2.6 Safety labels on the water pump 3.1 Improper use The following safety labels and instructions are attached WARNING! to the water pump (Fig. 1) and must be ob-served.. Danger in case of misuse! Misuse of the water pump can lead to dangerous sit- uations.
Inlet / outlet Ø G 1 “ G 1 “ Technical Data Suction height Engine speed 2850 min ¹ 2850 min ¹ Type GP 1105 C GP 1105 S Engine power 1100 W 1300 W Length 379,5 mm 470 mm Cooling...
Device description 11 Filler neck Garden pump GP 1105 P Garden pump GP 1105 C Fig. 5: Description GP 1105 P Fig. 3: Description GP 1105 C 1 Filler neck 1 Carrying handle 2 Water drainage connection 2 Fan 3 Carrying handle...
Device description Garden pump GP 1306 S ATTENTION! Make sure that the water tank of the pump is always filled with water before starting the pump. Dry run- ning may damage the pump. Display functions GP 1105 S Fig. 6: Description GP 1306 S 1 Drainage connection Fig.
Installation Automatic function: ATTENTION! During normal operation of the water pump, the LCD dis- play will show either „Pressure“ or „Flow“. As soon as the When installing the unit, make sure that the motor is adequately ventilated. water supply is closed and no more water flows, the pump switches off.
1 meter away from building walls and other equip-ment during operation. Do not place flammable objects near the engine. Wear protective cloth! Wear safety shoes! Fig. 9: Connection of the suction pipe GP 1105 C Wear safety glasses! 1 Drain plug 2 Water pump 3 Wasser tap...
Operation Step 1: Seal all screwing of the suction hose with thread 10 Operation tape so that no leaks can occur. DANGER! Step 2: Connect the suction line (7, Fig.9) to the pump. Danger to life due to electric shock! The suction line should have at least an internal There is danger to life when in contact with live com- diameter of 25 mm and must be kink-, pressure-...
Operation 10.1 Fill the pump with water 10.2 Starting the water pump ATTENTION! ATTENTION! Before starting the motor, the pump must be com- Make sure that the pump is properly placed and pletely filled with water. ready for use. Check if all hose connections are tight. Dry running can damage the pump.
Care, maintenance and repair 11 Care, maintenance and repair 11.2 Maintenance and repair ATTENTION! ATTENTION! Maintenance and repair must always be carried out Before maintenance work, the pump must be dis- by qualified personnel; any damages parts can only connected from the mains. If it is not disconnected be replaced by original spare parts.
If you can not solve the problems with the your house components. water system yourself, then please contact your ne- arest CLEANCRAFT dealer. Please write down follo- You contributes to that these components are disposed wing information from the water pump or the opera- of separately and properly.
Page 17
Disturbances, possible causes and measures Malfunction Possible cause Measurement The motor is operating 1. The pump housing is not filled 1. Fill the pump housing with the water. but the pump does not with the water. pump liquid. 2. Infiltration of air into the suction 2.
Spare Parts 14 Spare Parts Example The fan for the water pump GP 1105 C must be ordered. The fan wheel has the number 35 in the spare part dra- DANGER! wing. Danger of injury by the use of wrong spare parts!
In case of the service, the following drawing shall help to identify the necessary spare parts. If necessary, send a copy of the parts drawing with the marked components to your dealer. Fig. 10: Spare Parts Drawing GP 1105 C GP - Series | Version 1.03...
Spare Parts 14.3 Spare Parts Drawing GP 1105 P 14.4 Spare Parts Drawing GP 1105 S Fig. 12: Spare Parts Drawing GP 1105 S Fig. 11: Spare Parts Drawing GP 1105 P GP - Series | Version 1.03...
Wiring Diagrams 15 Wiring Diagrams GP 1105 S Fig. 14: Wiring Diagram GP 1105 S GP 1306 S, 1105 P und 1105 C Fig. 15: Wiring Diagram GP 1306 S, 1105 P and 1105 C GP - Series | Version 1.03...
Cleancraft® Sauggeräte Product group: Garden Pump Machine type: GP 1105 C - GP 1105 S - GP 1105 P - GP 1306 S Designation of the machine: 7521100 - 7521200 - 7521300 - 7521205 Item number: ____________________...
Need help?
Do you have a question about the GP 1105 C and is the answer not in the manual?
Questions and answers