Page 1
User Guide Guía del usuario Jump • Charge • Power Jump Starter / Power Bank Model/Modelo: JS-8000N CRANKING CURRENT: 200 Amps PEAK CURRENT: 400 Amps USB: 2x5V/2.4A, 12V/10A BATTERY CAPACITY: 8000mAh/29.6Wh FULLY CHARGE IMMEDIATELY AFTER PURCHASE. Fully recharge after each jumpstarting, or every 3 months to ensure...
10. When jump starting your vehicle do not place Jump Starter on the ground or at a height less than 18 inches. 11. Never charge or jump start a frozen battery. Store this item and charger in a cool dry place. JS-8000N USER GUIDE PAGE 3...
Page 4
State of California to cause cancer and birth defects or other reproductive harm (California law requires this warning to be given to customers in the State of California). Wash hands after handling. JS-8000N USER GUIDE PAGE 4...
Over Heat Protection. This product can instantly jump start most single battery vehicles, up to 30+ (over 30) times on a full charge. This product is also equipped with USB power output, LED flashlight and a 12VDC power output. JS-8000N USER GUIDE PAGE 5...
Page 6
About the JS-8000N: 1) Flashlight 2) Battery Capacity 3) 5V/2.4A Output 4) 15V/1A Input Built-In 8000mAh Lithium Ion Battery Power Button OUT 5V 2.4A Battery Status / Output Display 3 Mode Dual LED Flashlight EC5 Engine Start Socket (2) 5V/2.4A USB Outputs...
One sound Ready for connection to vehicle battery. Jumper cable and vehicle battery are One sound connected. Ready to start the engine. Lithium battery voltage in Slow flash No buzzer jump starter is low. JS-8000N USER GUIDE PAGE 7...
(NEG or POS) is connected to the chassis. For a negative grounded vehicle (most common): connect the RED POSITIVE jumper clamp first to the positive battery terminal, then JS-8000N USER GUIDE PAGE 8...
Connect the Jump Starter to the vehicle battery (Red LED keeps on and green LED is off), press and hold BOOST button for 3 seconds (after a buzzer sound, the green LED is on and red LED is off). “BOOST” is used JS-8000N USER GUIDE PAGE 9...
Page 10
Plug the other end of DC charging adapter into vehicle’s cigarette lighter socket. Fully charge the unit. Engine must keep running during entire charge. When charging is completed, unplug the DC charging adapter from the JS-8000N USER GUIDE PAGE 10...
Connect the jump starter to 12V devices by the incuded accessory. You do not need to press the Power button as the EC5 12VDC output is ALWAYS activated. When the battery voltage of the jump starter is too low, 12V devices will stop running/charging. JS-8000N USER GUIDE PAGE 11...
Page 12
Contact Smartech Inc. Customer Service and Smartech Inc. will troubleshoot any issue via phone or e-mail. If the problem is not corrected by this method, Smartech Inc. will, at its option, authorize evaluation, repair or replacement of the defective part or component at a Smartech Inc.
Page 13
Problems caused by parts that are not original parts. Limits of Implied Warranty and Consequential Damage Smartech Inc. disclaims any obligation to cover any loss of time, use of this product, freight, or any incidental or consequential claim by anyone from using this product.
Need help?
Do you have a question about the JS-8000N and is the answer not in the manual?
Questions and answers