CAREFULLY READ THE INSTRUCTION MANUAL. If instructions are not followed, there is a risk of injury, damage of the appliance and loss of the right to free warranty service. The Manufacturer shall not be held liable for damage arising from the failure to observe the instructions contained in this manual.
Page 4
Air the room in which the appliance is placed for a few minutes (the size of the • room for a product containing isobuthane / R600a must be at least 4 m ) to avoid damage to the cooling system. C-Pentane is used as blowing agent in theinsulation foam and it is a flammable gas.
CAUTION! If the installed interior lighting diode (LED) lamp for the cooling – device is not functioning, contact the maintenance and repair representative for replacements. LAMPS CAN BE REPLACED ONLY BY THE MAINTENANCE AND REPAIR REPRESENTATIVE. If the appliance is out of order and it is not possible to repair it by means of given recommendations, unplug it, open the doors and call the service expert.
Page 6
Do not cover the ventilation holes at the top of the appliances – it must be a good air • circulation around the appliance. There should be a gap of at least 10 cm between the top of the appliance body and any furniture that may be above it. If this requirement is not followed, the appliance consumes more electrical energy and its compressor may overheat.
THE APPLIANCE BASIC PARTS (see page 1. fig. 1) On/ off switch for interior light Adjustable height shelves I -(ON) O –(OFF) Thermostat knob Thaw water channel cleaner Thermostat indicator Thermometer (if available) Electricity supply indicator When the appliance is connected to Condenser the electricity supply, the green indicator light is illuminated.
Page 8
Remember that before cleaning the back part of the appliance body you must disconnect the appliance from the electrical energy supply socket by pulling the plug out of the electricity outlet. Protect the appliance inner surfaces and plastic parts from fats, acids •...
Remarks on the appliance operating noise. As the appliance operates and goes through the freezing cycle, various noises will be emitted. This is normal and is not a sign of any malfunction. As the refrigerant circulates around the refrigeration system, it causes sounds like •...
Need help?
Do you have a question about the CD29DM and is the answer not in the manual?
Questions and answers