Table of Contents
Advertisement
Chapter 2 Hardware Installation
Cleaning
USB Cable
Connect the USB port of your PC and the Switch using a standard USB cable. A cable with a Type A connector for the
PC end, and a Type B connector for the switch end must be used.
Standard USB cables are readily available from a variety of computer stores.
Terminal
The following configuration should be used in HyperTerminal:
Port Settings: 115200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
WARNING – Explosion Hazard – The USB connection is for temporary connection only. Do not use,
connect, or disconnect unless the area is known to be non-hazardous. Connection or disconnection in an
explosive atmosphere could result in an explosion.
AVERTISSEMENT - Risque d'explosion - La connection USB est pour la connexion temporaire seulement. Ne
pas utiliser, connecter ou déconnecter sauf si la zone est connue pour être non dangereuse. Connexion ou la
déconnexion dans une atmosphère explosive pourrait entraîner une explosion.
Cleaning
Clean only with a damp cloth. Excess moisture or harsh chemicals can cause damage to the unit.
28
Drawing No. LP0982
Revision C
NT24k® Modular Series Managed
Gigabit Ethernet Switches
Advertisement
Table of Contents
