87307 I/O Controller Configuration; 87307 I/O Controller - Compaq Deskpro 4000N Technical Reference Manual

Compaq personal computer user manual
Hide thumbs Also See for Deskpro 4000N:
Table of Contents

Advertisement

Chapter 4 System Support
4.6.2

87307 I/O CONTROLLER CONFIGURATION

The 87307 I/O controller contains various functions such as the keyboard/mouse interfaces,
diskette interface, serial interfaces, and parallel interface. Software control of these interfaces
uses standard AT-type I/O addressing. Firmware configuration of these functions uses indexed
ports unique to the 87307. In this system, hardware strapping selects I/O addresses 015Ch and
015Dh at reset as the Index/Data ports for accessing the configuration registers of the logical
devices within the 87307. The hardware strapping also places the 87307 into PnP motherboard
mode. Table 4-18 lists the PnP standard configuration registers for the devices within the 87307.
Table 4–18. 87307 I/O Controller PnP Standard Control Registers
87307 I/O Controller PnP Standard Configuration Registers
Index
Function
00h
Set RD_DATA Port
01h
Serial Isolation
02h
Configuration Control
03h
Wake (CSN)
04h
Resource Data
05h
Status
06h
Card Select Number (CSN)
07h
Logical Device Select:
00h = 8042 Controller (Keyboard I/F)
01h = 8042 Controller (Mouse I/F)
02h = RTC/APC Configuration
03h = Diskette Controller
04h = Parallel Port
05h = UART 2 (Serial Port B / IrDA)
06h = UART 1 (Serial Port A)
07h = GPIO Ports
08h = Power Management
20h
Super I/O ID Register (SID)
21h
SIO Configuration 1 Register
22h
SIO Configuration 1 Register
23h
Programmable Chip Select Configuration Index
24h
Programmable Chip Select Configuration Data
30h
Logical Device Activate
31h
Logical Device I/O Range Check
60,61h
Logical Device Data Base Address
62,63h
Logical Device Command Base Address
70h
Logical Device Interrupt Select
71h
Logical Device Interrupt Type
74,75h
Logical Device DMA Assignment
F0h
Logical Device Configuration
F1h
Drive ID (Logical Device 03 only)
The configuration registers are accessed by writing the appropriate logical device's number to
index 07h and writing the desired offset to the index register. The data is then either written to or
read from the data register.
4-42
Compaq Deskpro 4000N and 4000S Personal Computers
Table 4-18.
First Edition - September 1997
Reset Value
00h
00h
00h
00h
A0h
D6h
02h
00h
00h
--
--
--
--
--
--
--
--
--

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Deskpro 4000s

Table of Contents