SAFETY INSTRUCTIONS that they do not play with the appliance. - Use this unit -This machine can be described this manual. used by people with mishandling and any reduced physical, contrary sensory mental instructions capabilities or lack of experience shall in no case be the knowledge if they have responsibility been given supervision...
Page 3
damaged. this cleaning agent case, do not use the supplied appliance and take it recommended by the to your dealer for manufacturer. Use of inspection other cleaning repair. chemical agents may affect the safety of the The voltage indicated machine. on the rating plate of appliance -WARNING:...
Page 4
-WARNING: High backflow preventers is pressure cleaners shall considered not be used by children non-potable. or untrained personnel. -WARNING: -The machine shall be machine must disconnected from its disconnected from the power source during power supply during cleaning cleaning maintenance maintenance when replacing parts when replacing parts...
Page 5
outdoor use, and the -The appliance must be connection has to be connected to a water kept dry and off the supply using a new set ground. of hoses; the old pipe recommended that this must accomplished reused. means of a cord reel -Make sure that there are which keeps the socket no exhaust emissions...
Page 6
recommended that the pressure of 10 bars. power supply of this -If the device is to be machine includes connected to a drinking residual current device water network that interrupts power if (exclusively in Europe), earth leakage an appropriate network exceeds 30 mA for 30 valve must be installed ms or a device that will...
Page 7
untimely resetting of situations or accidents thermal cut-out, may occur. Do not use this device must not be it indoor, in places powered where are exhausted external switch, such gases, etc. timer, -In case of accidents or connected to a circuit breakdowns, stop to that regularly...
Page 8
when leaving remain upright. machine unattended. -Do not use the tool in avoid dangerous dangerous situations situations in the event or when an accident of an accident (for has occurred. Do not example, contact with use indoors, in places or spill of detergents) where gases can be or equipment failure emitted, etc.
Page 9
The following dangers can arise in connection at the appliance itself. with the structure and design of this product: Health defects resulting from vibration emission if the product is being used over The appliance must not be directly long periods of time or not adequately connected to the public drinking water managed and properly maintained.
Page 10
8. Support storage 9. Water outlet Sound pressure Lpa: 75 dB(A) K= 3 level dB(A) 10.Wheel 11. Spray gun 12.Spray lance Vibration 3 m/s² K= 1,5 m/s² 13. Water inlet connector 14. High pressure hose 15. Nozzle cleaning tool (in option depending Assembly the model) Mount loose parts delivered with...
Page 11
8.Connect the high-pressure hose to the trigger gun Connect the sliver end of the high-pressure hose to the trigger gun and twist the nut as indicated to secure the connection 5.Installing the spray wand -Insert firmly the spray wand into the gun and rotate it clockwise to lock it.
Page 12
Operation more than 25 meters) with a diameter of 12.5 mm to avoid back pressure and any potential damage to your appliance. Make ATTENTION sure it can withstand water and a maximum pressure of 10bar (0.1Mpa). If Dry running of more than 2 minutes leads to you want to connect your device to other damage of the high-pressure pump.
Page 13
Release the lever of the trigger gun; the Only separate the high-pressure hose from device will switch off again and stop the water the trigger gun or the device when there is no jet. High pressure remains in the system. pressure in the system.
Page 14
Storing the appliance High pressure hose • Park the machine on an even surface. The high-pressure hose is specially • Detach spray lance from the trigger gun. constructed with reinforced walls it can be • Pull the high-pressure hose out of the trigger easily damaged and should be stored gun.
Troubleshooting DANGER Risk of electric shook. Turn off the appliance and remove the main plug prior to performing any care and maintenance work. Repair work and work on the electrical components may not only be performed by an authorized customer service. You can rectify minor faults yourself with the help of the following Symptom Cause Recommended action...
Page 16
BUILDER SAS ZI, 32 rue Aristide Bergès – 31270 Cugnaux - France Declares that the machinery designated below: ELECTRIC PRESSURE WASH ER Ref.: HNHP2065B500L Serial number: 20210762156-20210762655 Complies with the provisions of the Directive “machinery” 2006/42/CE and national laws transposing it:...
WARRANTY WARRANTY The manufacturer guarantees the product against defects in material and workmanship for a period of 2 years from the date of the original purchase. The warranty only applies if the product is for household use. The warranty does not cover breakdowns due to normal wear and tear. The manufacturer agrees to replace parts identified as defective by the designated distributor.
PRODUCT FAILURE WHAT TO DO IF MY MACHINE BREAKS DOWN? If you bought your product in a store: a) Empty the fuel tank. b) Make sure that your machine is complete with all accessories supplied, and clean! If this is not the case, the repairer will refuse the machine.
WARRANTY EXCLUSIONS THE WARRANTY DOES NOT COVER: • Start-up and setting up of the product. • Damage resulting from normal wear and tear of the product. • Damage resulting from improper use of the product. • Damage resulting from assembly or start-up not in accordance with the user manual. •...
Need help?
Do you have a question about the HNHP2065B500L and is the answer not in the manual?
Questions and answers