Toyota GR Corolla Manual page 286

286
6-4. Do-it-yourself maintenance
procedure cannot be completed
after performing the above proce-
dure, contact your Toyota dealer.
Registering ID codes
The tire pressure warning valve
and transmitter is equipped with
a unique ID code. When new
tire pressure warning valves and
transmitters are installed, new
ID codes must be registered in
the tire pressure warning com-
puter.
 ID codes can be registered by
yourself, but depending on
the driving conditions and
driving environment, registra-
tion may take some time to
complete.
 When using a wheel set
which all of the ID codes have
already been registered, the
wheel set can be changed in
a short amount of time.
Before performing ID code reg-
istration, make sure that no
wheels with tire pressure warn-
ing valve and transmitters
installed are near the vehicle.
1
Park the vehicle in a safe
place and turn the engine
switch off, wait for approxi-
mately 20 minutes or more,
and then start the engine.
The ID code registration procedure
cannot be performed while the
vehicle is moving.
2
Select of the multi-infor-
mation display and then
press .
3
Press or
"Vehicle Settings" and then
press and hold
4
Press or
"TPWS setting" and then
press .
5
Press or
"Tire Set Switching" and then
press .
6
Press or
"Register New Valve / ID" and
then press .
7
Press or
"Tire Set 1" or "Tire Set 2".
Then press .
ID codes will be registered to the
displayed wheel set.
To change the wheel set to be reg-
istered, select the displayed set,
and then select the wheel set you
wish to register.
If ID codes have already been reg-
istered for that wheel set, the tire
pressure warning light will slowly
blink 3 times, and a message indi-
cating that change is occurring will
be displayed on the multi-informa-
to select
.
to select
to select
to select
to select