Advertisement
Available languages
Available languages
Cold / hot water version
1. Push the lock located on the top of the water cooler to open it (figure 1).
2. Remove the hygiene kit from its packing and put on the gloves to ensure hygiene (figure 2).
3. Take the hot water adaptor and disconnect the cap.
4. Remove the white nozzle tube and place the cap on the pipe hole (figure 4).
5. Remove the receptacle from the kit and insert it on the hot water adaptor respecting the right
direction (figure 5).
6. Replace the receptacle + hot water adaptor in the kit. Push it until you feel the "click". The blue
nozzle tube must be place on the right when the air filter is positionning towards rear(figure 6).
7. Before insert the receptacle, place the blue nozzle tube towards right and the air filter towards
rear. Insert the receptacle's notches inside those of the kit's bracket, and the hot water adaptor
inside the silicone adaptor (figure 7 and 8).
8. Press the cold water tap, while inserting the « cold water » tube (blue nozzle) inside the right
distribution (figure 5).
9. Then, pinch the tube in order to insert it below the notches.
smooth part of the tube and not on the undulating part.
10. Close the top of the water cooler.
11. Remove the protecting cap of the bottle (figure 7).
12. Place the bottle as straight as possible not to avoid damaging the receptacle.
13. Press on each tap to initiate the water inside the tubes until flowing.
14. Switch on the water cooler.
15. Press on the ON-OFF button of the heater, located at the left of the cooler.
figure 1
figure 5
figure 2
figure 6
- page 8 -
CAUTION: Place the notches on the
Make sure that the tube is not pinched.
Hot water adaptor
figure 3
figure 7
figure 4
figure 8
Advertisement
