RCA RDW2480 Owner's Manual page 29

Child Lock
Child lock can be turned on by pressing and
holding the 'Extra' and Half Load / Hi- Temp
keys for 3 seconds. When Child lock is
activated all LED's flash on the machine and
"CL" is shown on the display. To deactivate
the child lock repeat the above instructions,
all LED's and "CL" flash twice and then
remain off.
Cancelling The Program
i. There might be residues of detergent or
rinse aid left in the machine and/or on the
pieces being washed depending on the step
the program you have cancelled was in.
Salt Indicator(Model Depending)
Please check the salt indicator on the control
panel to see whether there is adequate
amount of softening salt in the dishwasher or
not. You need to refill the salt reservoir with
salt whenever salt warning indicator appears
on the control panel of your machine.
Rinse Aid Indicator
Please check the rinse aid indicator on the
control panel to see whether there
is adequate amount of rinse aid in the
dishwasher or not. You need to refill the rinse
aid reservoir with rinse aid whenever rinse
aid warning indicator appears on the control
panel of your machine.
End of Program
End of program indicator will light up
continuously when the washing programme is
over.
1.Open the door of the machine
2.Press On/Off key to turn off your machine.
3.Close the tap
4.Unplug the machine from the socket
i. Leave your dishes in the machine about 15
minutes to cool down after they are washed.
Your dishes will dry in a shorter
time if you leave the door of your machine
ajar during this period. This process will
increase the drying effectiveness of your
machine.
Water Cut - Off Warning
If mains water is cut or water inlet tap is
turned off the machine can not take water in
and "FF" will flash continuously on the display.
As long as the problem continues, the
washing program is stopped and water inlet is
checked regularly by the user. If the water
inlet is provided, the machine gets ready to
start a new program.
Overflowing Warning
If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and "F1" will
flash on the display. As long as the
overflowing continues, safety algorithm will be
active and try to discharge the water. If
overflowing stops and safety is assured, "F1"
will disappear. If "F1" does not disappear,
there is a permanent fault. In this case, the
authorized service should be contacted.
29