RCA RDW2480 Owner's Manual page 28

Programming The Washing Time
Delay Timer
If an economical electricity tariff is applied in
your region, you can use the Delay Timer
function to wash your dishes during
appropriate hours. You can delay the start of
the selected program until 19 hours. Delay
Timer cannot be set after the program starts.
1.Press the Delay Timer function key after
selecting the washing program and other
auxiliary functions.
2.Once you press the Delay Timer key,
Display will show "1h" and Display will show
program number, program duration and
delay time alternately for 2 seconds.
3.Set the desired time by pressing the Delay
Timer key. Time will increase with the
increments of 1 hour every time you press
the key.
4.In order to start the selected program with
delay, Start/Pause key should be pressed.
The delay led will light during delay timer is
active.
NOTE: Assume that you have selected a
program with delay and pressed Start/ Pause
key. After a length of time, you have opened
the door of the machine. If the door of the
machine is closed within 4 seconds, the
machine resumes on for the duration of
delay timer. If the door stays open for more
than 4 seconds, delay timer will be paused.
In this case; to resume the delay timer, Start/
Pause key must be pressed.
Changing the settings while Delay Timer is
enabled
After the Delay Timer function is activated,
you cannot change the washing program,
auxiliary functions or the duration of delay
time.
To cancel the Delay Timer function
1. Press and hold Start/Pause key for 3
seconds.
2. After 3 seconds, "1" appears on the
display. At the end of the cancellation
process, "0" appears on the display and
delaying process is cancelled.
28
You can select and start a new program
following the cancellation of Delay Timer
function.
Delay Timer function can not be set after the
program starts.
Starting The Program
In order to start your machine after selecting
the program and auxiliary functions, Start/
Pause key must be pressed. Once the
program starts, the estimated time remained
to the end of the program will appear on the
display. Washing steps can be monitored by
the LED indicators. These highlight whether
the programme is in the wash, rinse, dry or
end stage. The machine will be silent for
approximately 40-50 minutes during the
drying stage.
i. Your machine performs water softening
depends on model hardness level of the
supply water (Model depending). Remaining
time displayed towards the end in some
programs can be different from the time
indicated at the beginning due to this process.
The total time can also change while the
program is running depending on the ambient
temperature where your machine is installed,
temperature of the supply water and amount
of the dishes.
ii.i. Pay attention not to open the door
the machine when it is running. Stop the
machine by pressing Start/Pause key. In
other situation, the machine will stop when
the door of the machine is opened. If any key
is not pressed the machine will be paused
automatically 4 seconds after the door is
opened. To continue the program, close the
door and press Start/Pause key. If the door is
closed back within 4 seconds after the door is
opened, the program will continue
automatically.
Program and auxiliary functions cannot be
set/changed after the program has started.
You can select and start a new program
following the pause or cancellation of the
program.