Selecting The Input Source - Onkyo TX-SR804 Quick Manual

Turning on & Using Automatic Speaker Setup
With the supplied speaker setup microphone, use the Automatic Speaker Setup function.
Before using this function, connect and position all your speakers.
1
AV receiver
STANDBY/ON
or
2
ENTER
3
ENTER

Selecting the Input Source

1.
Use the AV receiver's input selector buttons
to select the input source.
To select the input source with the remote controller,
press the [RECEIVER] button, and then use the
INPUT SELECTOR buttons.
2.
Start playback.
3.
To adjust the volume, use the MASTER VOL-
UME control, or the remote controller's [VOL]
button.
SN 29344330
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved.
Remote
Press the [STANDBY/ON] button on the AV receiver or press the remote
controller
controller's [RECEIVER] button followed by the [ON] button to turn on
RECEIVER
the AV receiver.
Turn on the TV and select the input to which the AV receiver is connected.
ON
SETUP MIC
Auto Speaker Setup
------------------------
Push Enter:Start
Caution! Loud sound.
Auto Speaker Setup
------------------------
Apply the Results
ENTER
Check the Results
Retry
Retry with
Test noise Level up
Cancel
Put the speaker setup microphone
MIC
position
in the listening position, and con-
nect it to the SETUP MIC jack on the
front panel.
And press [ENTER].
The automatic speaker setup starts.
The whole process takes about 2 minutes.
When you've finished the setup,
press the Up and Down [
tons to select "Apply the Results,"
and then press [ENTER].
Disconnect the speaker setup
microphone.
STANDBY/ON
STANDBY
ZONE 2
PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4
1
]/[ ] but-
3
MASTER VOLUME
TAPE TUNER CD PHONO DISPLAY
PUSH TO OPEN
* 2 9 3 4 4 3 3 0 *
I0609-1