Connecting Onkyo Components; Connecting The Power Cord; Remote Control - Onkyo TX-SR574 Instruction Manual

Connecting Your Components—Continued
Connecting Onkyo
Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (con-
nection in the hookup examples) (see pages 22 to 30).
a
Step 2: Make the connection.
Step 3: If you're using an MD, CDR, or HDD component, change the Input Display (see page 33).
With (Remote Interactive), you can use the following special functions:
■ Auto Power On/Standby
When you start playback on a component connected via
turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all compo-
nents connected via
OUTLET on the AV receiver.
■ Direct Change
When playback is started on a component connected via
as the input source. If your DVD player is connected to the AV receiver's multichannel DVD input, you'll need to
press the [MULTI CH] button to hear all channels (see page 38), as the Direct Change
FRONT DVD IN jacks.

■ Remote Control

You can use the AV receiver's remote controller to control your other
remote controller at the AV receiver's remote control sensor instead of the component. You must enter the appropri-
ate remote control code first (page 55).
Notes:
• Use only cables for
cables are supplied with Onkyo players (DVD,
CD, etc.).
• Some components have two
connect either one to the AV receiver. The other
jack is for connecting additional
components.
• Connect only Onkyo components to
Connecting other manufacturer's components
may cause a malfunction.
• Some components may not support all
tions. Refer to the manuals supplied with your
other Onkyo components.

Connecting the Power Cord

• Connect the AV receiver's power cord to a suitable wall outlet.
Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.
Components
will also go on Standby. This function will not work on components connected to an AC
connections.
jacks. You can
-capable
jacks.
func-
, if the AV receiver is on Standby, it will automatically
, the AV receiver automatically selects that component
-capable Onkyo components, pointing the
ANTENNA
AM
COMPONENT VIDEO
DIGITAL IN
IN 3 IN 2 IN 1 OUT
COA
Y
XIAL
VIDEO 2 VIDEO 1
OPTICAL
P B V
1
REMOTE
CONTROL
P R S
2
IN
OUT
3
IN OUT IN IN OUT
L L L
REMOTE
CONTROL
R R R
CD TAPE VIDEO 2 VIDEO 1
e.g., CD player
e.g., DVD player
function only selects the
IN
L
R
SURROUND BACK
SPEAKERS CD
FM 75
L
MONITOR
DVD OUT
R
FRONT
IN IN
IN FRONT SURROUND CENTER SURR BACK L
R
SUB
WOOFER
DVD
DVD
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
31