Listening To The Radio; Listening To Am/Fm Stations - Onkyo TX-SR574 Instruction Manual

Listening to the Radio

Listening to AM/FM stations

STANDBY/ON
STANDBY
MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3
VCR
PHONES
SPEAKERS
A B TONE STEREO LISTENING MODE
With the built-in tuner, you can enjoy AM and FM radio
stations.
1 Use the [TUNER] input selector
TUNER
button to select AM or FM.
In this example, FM has been selected.
Band
(Actual display depends on country.)
■ AM Frequency Step Setup
(not North America and Europe)
You must specify the AM frequency step used in your
area. Note that when this setting is changed, all radio
presets are deleted.
1 Press the [SETUP] button, use the Up
and Down [ ]/[
Hardware Setup," and then press
[ENTER].
2
Use the Up and Down [
to select "AM Freq," and then use the
Left and Right [
select:
10 kHz: Select if 10 kHz steps are used in your
area.
9 kHz: Select if 9 kHz steps are used in your
area.
3
Press the [SETUP] button.
Setup closes.
TUNER
TUNING
MASTER VOLUME
TUNING PRESET
ENTER
TAPE TUNER C D RETURN SETUP
VIDEO 3 INPUT
VIDEO L AUDIO R
DIGITAL TUNING
DISPLAY INPUT DIMMER MEMORY MODE
CLEAR
TUNING MODE
Frequency
] buttons to select "0.
]/[ ] buttons
]/[ ] buttons to
Tuning into AM/FM Radio Stations
■ Auto Tuning Mode
1
Press the [TUNING MODE] button
TUNING
MODE
so that the AUTO indicator
appears on the display.
2
Press the TUNING Up or Down
[ ]/[ ] button.
TUNING PRESET
Searching stops when a station is
found.
■ Manual Tuning Mode
1
Press the [TUNING MODE] button
TUNING
MODE
so that the AUTO indicator disap-
pears from the display.
2 Press and hold the TUNING Up or
Down [ ]/[ ] button.
TUNING PRESET
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
The American model changes FM frequency in 0.2 MHz
steps, 10 kHz steps for AM. For other models it's
0.05 MHz steps for FM and 9 kHz (or 10 kHz) steps for
AM.
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator also appears.
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Note:
• You can also use the remote controller's Up and Down
[ ]/[ ] buttons to tune the radio.
TUNED AUTO
FM STEREO
39