Cleaning And Care; Maintenance; Repair; Storage - Parkside PHET 15 C2 Translation Of The Original Instructions

Typical examples
Base material
Plywood
Fibre board
Softwood
(e.g. pine)
The crown of the staple or head of the nail should
be flushed with the top of the material being
fastened as shown.
If the crown of the staple or head of the nail is not
flush with the top of the material being fastened,
it means it is too long. In this case, use the next
shorter staple or nail for optimal results.

Cleaning and care

Always activate switch lock
lock the trigger
the product from the mains before
starting any works on the product.
Do not use chemical, alkaline, abrasive or
other aggressive detergents or disinfectants to
clean this product as they might be harmful
to its surfaces.
Never allow fluids to get into the product.
The product must always be kept clean, dry
and free from oil or grease.
Remove debris from it after each use and
before storage.
Regular and proper cleaning will help ensure
safe use and prolong the life of the product.
Material to be
fastened /thickness
≤ 1 mm
1–3 mm
≤ 3 mm
3–5 mm
to
1
and disconnect
2
Staples
6–8 mm
8–10 mm
8–10 mm
10–14 mm
If the power cord needs to be replaced, this
must be carried out by the manufacturer or
an official representative in order to avoid
safety hazards.
Use a soft brush for areas that are hard
to reach.
Clean the product with a dry cloth.

Maintenance

Always activate switch lock
lock the trigger
the product from the mains before
starting any works on the product.
The product is maintenance-free.
Before and after each use, check the product
for wear and damage.

Repair

This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.

Storage

Clean the product as described above.
Remove staple or nail from magazine
activate switch lock
before storage.
Store the product, nail and staple in dry,
frost-free and well-ventilated place.
Nails
8–10 mm
12–14 mm
10–12 mm
12–15 mm
to
1
and disconnect
2
and
4
to lock the trigger
1 2
GB 11