Installing - Magicfx CO2 Dominator User Manual

User Documentation MAGICFX® CO2 Dominator

10. INSTALLING

Prepare the CO2 Dominator for use as follows:
1.
2.
Page 11
CAUTION:
This indicates that the equipment may be damaged if procedures are not
carried out in the proper manner.
DANGER WARNING:
The MAGICFX® CO2 Dominator may only be installed by authorized
adults.
Place the CO2 Dominator on a flat and
stable surface.
Make sure the on / off switch is in 'off'
position and then connect the power
cable. The CO2 Dominator works on 230V
~ 50/60Hz. You need a powercon cable to
connect the CO2 Dominator to a 230V
powersource. The CO2 Dominator is also
equipped with a PowerCon out connector.
This allows you to link multiple units in 1
line.